How to remove and install Washer Pump and Washer Reservoir on BMW 325i?

The reservoir of the washer is located behind the right front wheel well. To remove it, remove the inner fender liner. Then unclip the wiring harness and hose from the reservoir clips, disconnecting the filler hose as well. Maneuver away from fenderwell by removing bolt and disconnect electrical connectors and hoses from reservoir components. Reinstall in reverse order of removal ensuring that locating lugs on rear edge of reservoir engage properly with corresponding slots in inner fender. Fill the reservoir and inspect for leakage. They can be removed following the same guidelines used earlier to remove a windshield washer pump assembly, but only if you are mechanically inclined to do so can you proceed as they are disassembled in such a way that they cannot be reassembled correctly. Disconnect electric wiring connector(s) or hose(s) connected on washer pump(s), then rotate carefully clockwise after which raise them up out of container (reservoir). After proper inspection, replace damaged or worn-out pump sealing grommet(s). Install As mentioned above except use new sealant grommet when required.One may also follow the steps given above to withdraw washer bottle level switch. Rotate level switch counterclockwise; pull off from container (reservoir). Install As per removal procedure while using another sealant grommet when necessary.Refill and check for leaks.The windscreen cleaner nozzle can be taken out by removing cabin air filter cover followed by removing hoses and electrical connections.Press back on spray nozzle until it pops up at front edge then lift forward to release it from panel.Re-assemble the item opposite to what was done during detachment.The headlamp cleaning system nozzle will require prying out of this area below headlamp whereafter one can now remove cover from nozzle after separating it.Remove front bumper then detach heating element electrical connector.Apart from detaching mounting clip first then remove thread pipe section.Install similar manner like in removal process.The rear window washer nozzle can be taken out by removing high-mount brake light, releasing the clip, disconnecting the hose, and pulling it from high mount brake light.The reverse of the removal process will include aiming the nozzle at specified location on window.Run by central control module assembly located within main fusebox.

Genuine BMW 325i Washer Pump

Windshield Washer Pump

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Series

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

11 Washer Pumps found

View related parts
BMW 325i Washer Pump
Part Number: 67127302589
$62.13 MSRP: $87.95
You Save: $25.82 (30%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Wash Pump/Fluid Container; Front Washer Pump
- Replaces: 67-12-6-934-159
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 2006 BMW 325i | Sedan(E90)
View related parts
BMW 325i Washer Pump
Part Number: 67128362154
$62.13 MSRP: $87.95
You Save: $25.82 (30%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Wash Pump; Rear Washer Pump
- Replaces: 67-12-8-377-612
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 2001-2005 BMW 325i | Sedan M54 Engine(E46), Sedan M56 Engine(E46), Sedan(E46), Wagon M54 Engine(E46), Wagon M56 Engine(E46), Wagon(E46)
- 1992-1995 BMW 325i | Convertible(E36), Sedan(E36)
View related parts
BMW 325i Washer Pump
Part Number: 67128377430
$91.69 MSRP: $131.97
You Save: $40.28 (31%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Wash Pumpe For Head Lamp Cleaning Device; Hose
- Position: Passenger Side
- Replaces: 67-12-6-973-097, 67-12-8-377-613
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 2001-2006 BMW 325i | Sedan M54 Engine(E46), Sedan M56 Engine(E46), Sedan(E46), Sedan(E90), Wagon M54 Engine(E46), Wagon M56 Engine(E46), Wagon(E46)
- 1992-1995 BMW 325i | Convertible(E36), Sedan(E36)
View related parts
BMW 325i Washer Pump
Part Number: 61661377830
$75.41 MSRP: $92.40
You Save: $16.99 (19%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Wash Pump/Fluid Container
- Position: Driver Side
- Replaces: 61-66-8-360-614, 67-12-8-360-244, 61-66-1-380-068, 61-66-1-380-066
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 1987-1995 BMW 325i | Convertible(E30), Convertible(E36), Coupe(E30), Sedan(E30), Sedan(E36)
View related parts
BMW 325i Washer Pump
Part Number: 61661368589
$57.39 MSRP: $70.33
You Save: $12.94 (19%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Wash Pump
- Replaces: 61-66-1-367-616
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 1987-1992 BMW 325i | Convertible(E30), Coupe(E30), Sedan(E30)
View related parts
BMW 325i Washer Pump
Part Number: 61661380066
$10.95 MSRP: $92.40
You Save: $81.45 (89%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Wash Pump
- Replaced by: 61661377830
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 1987-1992 BMW 325i | Convertible(E30), Coupe(E30), Sedan(E30)
View related parts
BMW 325i Washer Pump
Part Number: 61661380068
$75.41 MSRP: $92.40
You Save: $16.99 (19%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Wash Pump
- Replaced by: 61661377830
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 1992-1995 BMW 325i | Convertible(E36), Sedan(E36)
View related parts
BMW 325i Washer Pump
Part Number: 61678354625
$317.17 MSRP: $405.30
You Save: $88.13 (22%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Pump Headlight
- Replaced by: 61671378875
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 1992-1995 BMW 325i | Convertible(E36), Sedan(E36)
View related parts
BMW 325i Washer Pump
Part Number: 61671378875
$317.17 MSRP: $405.30
You Save: $88.13 (22%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Pump Headlight; Reservoir
- Replaces: 61-67-8-354-625
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 1992-1995 BMW 325i | Convertible(E36), Sedan(E36)
View related parts
BMW 325i Washer Pump
Part Number: 61668360614
$75.41 MSRP: $92.40
You Save: $16.99 (19%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Wash Pump
- Replaced by: 61661377830
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 1992-1995 BMW 325i | Convertible(E36), Sedan(E36)
View related parts
BMW 325i Washer Pump
Part Number: 61678357839
Product Specifications
- Other Name: Wash Pumpe For Head Lamp Cleaning Device
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 1992-1995 BMW 325i | Convertible(E36), Sedan(E36)

BMW 325i Washer Pump

The BMW 325i Washer Pump will send pressurized washer fluid to the windscreen nozzles from the reservoir to give drivers a clear view. A small, electric Washer Pump is located at the bottom of the fluid tank. When the stalk switch is tapped, a small impeller starts whirling, which pushes liquid through narrow hoses until it fans out evenly across the glass. The original pump design features a sealed plastic enclosure with a two-wire electrical connection and a molded grommet to prevent leaks into the engine bay. This basic Washer Pump design has been part of the model line for many years as the application requires a constant flow and modest pressure only. The Washer Pump for all BMW 325i variants is identical in function and configuration, so no alternative dual-stage or variable speed styles are listed. Choosing a substitute, therefore, revolves around matching the shape of the connector and the opening in the reservoir. Typically, parts and professional installation costs a modest amount. Thus, the Washer Pump is one of the simpler and more affordable service items for a BMW 325i.

If you are looking for OEM BMW 325i Washer Pump, we highly recommend to shop with us. Not only do we offer budget friendly prices, but we also provide fast delivery. In addition, we have a hassle-free return policy on all genuine BMW 325i Washer Pump that come backed by the manufacturer's warranty.

BMW 325i Washer Pump Parts Questions & Experts Answers

Washer Pump
67127302589
Q:
How to remove and install Washer Pump and Washer Reservoir on BMW 325i?
Posted by Roger Y.
A:
The reservoir of the washer is located behind the right front wheel well. To remove it, remove the inner fender liner. Then unclip the wiring harness and hose from the reservoir clips, disconnecting the filler hose as well. Maneuver away from fenderwell by removing bolt and disconnect electrical connectors and hoses from reservoir components. Reinstall in reverse order of removal ensuring that locating lugs on rear edge of reservoir engage properly with corresponding slots in inner fender. Fill the reservoir and inspect for leakage. They can be removed following the same guidelines used earlier to remove a windshield washer pump assembly, but only if you are mechanically inclined to do so can you proceed as they are disassembled in such a way that they cannot be reassembled correctly. Disconnect electric wiring connector(s) or hose(s) connected on washer pump(s), then rotate carefully clockwise after which raise them up out of container (reservoir). After proper inspection, replace damaged or worn-out pump sealing grommet(s). Install As mentioned above except use new sealant grommet when required.One may also follow the steps given above to withdraw washer bottle level switch. Rotate level switch counterclockwise; pull off from container (reservoir). Install As per removal procedure while using another sealant grommet when necessary.Refill and check for leaks.The windscreen cleaner nozzle can be taken out by removing cabin air filter cover followed by removing hoses and electrical connections.Press back on spray nozzle until it pops up at front edge then lift forward to release it from panel.Re-assemble the item opposite to what was done during detachment.The headlamp cleaning system nozzle will require prying out of this area below headlamp whereafter one can now remove cover from nozzle after separating it.Remove front bumper then detach heating element electrical connector.Apart from detaching mounting clip first then remove thread pipe section.Install similar manner like in removal process.The rear window washer nozzle can be taken out by removing high-mount brake light, releasing the clip, disconnecting the hose, and pulling it from high mount brake light.The reverse of the removal process will include aiming the nozzle at specified location on window.Run by central control module assembly located within main fusebox.
Answered by BMW Parts Specialist Chaz / Apr 05, 2023

Related BMW 325i Parts

Browse by Year

2006 Washer Pump 2005 Washer Pump 2004 Washer Pump 2003 Washer Pump 2002 Washer Pump 2001 Washer Pump 1995 Washer Pump 1994 Washer Pump 1993 Washer Pump 1992 Washer Pump 1991 Washer Pump 1990 Washer Pump 1989 Washer Pump 1988 Washer Pump 1987 Washer Pump