BMW 33207559933 Cv Axle Assembly Left

You can Select Your Vehicle to check if 33207559933 fits your vehicle.

For AWD models, when removing the front, start by having the vehicle on its wheels, remove the wheel trim/hub cap, and loosen the Axle Shaft retaining nut or bolt and the wheel bolts. Before loosening the Axle Shaft nut, use a hammer and punch to push out the staked portion of the nut. On F-series chassis models, always replace the Axle Shaft bolt and small compression spring whenever they are removed. Block the rear wheels, raise the vehicle front, support on jackstands, and take off the front wheel. Detach the ABS wheel speed sensor, set the brake caliper aside without disconnecting the brake fluid hose. Disconnect the stabilizer bar link from the strut and separate the tension strut and control arm from the knuckle. Push the Axle Shaft stub through the hub while pulling the steering knuckle outwards. Pry the inboard CV joint away from the front differential housing. For the right Axle Shaft, pry against the bearing bracket. For installation, remove the snap-ring from the Axle Shaft's inboard end and install a new one. Lubricate the nut-to-wheel bearing area, tighten the nut to the needed torque without oiling the threads, stake the nut post-tightening, and add new inner joint retaining bolts and plates, tightening them to the necessary torque.For the rear, with the vehicle on its wheels, remove the wheel trim/hub cap and loosen the Axle Shaft retaining nut and wheel bolts. Push out the staked portion of the Axle Shaft nut using a hammer and punch. Block the front wheels, raise the rear, and support on jackstands before removing the rear wheel. For E-series chassis, if removing the left Axle Shaft, remove the exhaust system tailpipe. Loosen and remove the stabilizer bar mounts, pivot the bar downwards. Mark alignment, then loosen and remove bolts securing the Axle Shaft CV joint to the rear differential. Withdraw the outer CV joint from the hub assembly. Tap or press it out if needed and then remove the driveshaft.For F-series chassis models, remove the Axle Shaft nut, push the axle slightly inwards, support the rear differential, then remove the mounting bolt/nuts and lower the differential. Pry the inboard CV joint away from the rear differential housing until the Axle Shaft is free, slide the Axle Shaft out of the differential, and have a pan ready for spilled lubricant. For installation, note the following: On E-series chassis models, install new inner joint retaining bolts and plates and tighten. On F-series chassis models, check the dust plate, replace the circlip on the Axle Shaft's end, and coat the seal contact with differential oil. Slide the Axle Shaft into the rear differential until an audible click is heard. Reinstall the rear differential assembly and refill it. Lubricate the nut-to-hub flange area, tighten the nut without oiling the threads, and then stake the nut once tightened.