BMW 33217547073 Left Rear Axle Shaft Assembly

For installation, follow these steps: On E-series chassis models, install new inner joint retaining bolts and plates and tighten. On F-series chassis models, check the dust plate, replace the circlip on the driveaxle's end, and coat the seal contact with differential oil. Slide the driveaxle into the rear differential until an audible click is heard. Reinstall the rear differential assembly and refill it. Lubricate the nut-to-hub flange area, tighten the nut without oiling the threads, and then stake the nut once tightened.

Begin by having the vehicle on its wheels, then remove the wheel trim/hub cap, and loosen the driveaxle retaining nut or bolt as well as the wheel bolts. Prior to loosening the driveaxle nut, use a hammer and punch to push out the staked portion of the nut. On F-series chassis models, it's important to always replace the driveaxle bolt and small compression spring when they are removed.