BMW 31303404065 Stabilizer Rubber Mounting

The Sway Bar Kit mounts to the front subframe, with the front Sway Bar Link attaching to the strut assemblies. To remove and install the Sway Bar Kit, Sway Bar Link, and Sway Bar Bushing, first raise the car and remove the front wheel. Next, remove the underbody splash shield. For the Sway Bar Bushing, fold back the wheel housing liner and remove the Sway Bar Bushing mount bolts, then slide the bushing out for removal. Installation is the reverse of removal, and it is important not to grease the bushings. For the Sway Bar Link, raise the car and remove the front wheel, then remove the Sway Bar Link mounting nut, using a thin wrench to counter hold the shaft of the Sway Bar Link ball joint while removing the nut. To remove the Sway Bar Kit, raise the car and remove the front wheel, then take off the underbody splash shield and lower the front subframe. Remove the Sway Bar Link from the Sway Bar Kit and take out the Sway Bar bracket bolts on both sides, sliding the stabilizer out from the front of the vehicle. Installation is the reverse of removal, ensuring to replace fasteners with new ones and check rubber mounts for damage, replacing them as needed.