Lift the car, dismantle the cargo compartment side panel and the rear seat bottom, and then the nut of the lower fixing of the seat belt and the bolt fixing the height adjuster of the reversing clip. If the seat belt height adjuster is being removed the two mounting screws should be removed at the same time as this may cause the adjuster to tilt. It is followed by the removal of mounting screws and seat belt guide and the last bolt for the mounting of seat belt reel. Slide the reel arrangement up somewhat and dra Files push this inward to disengage it from the body and then to eliminate the reel and belt arrangement down through the aperture in the side panel. If so, undo the bolts for the belt locks and then the belt lock where present: When reinstalling it very important to ensure that the locating tabs for the belt reel and lock are well placed. Remember that the elimination of the center rear seat belt entails the detachment of the rear seat backrest upholstery which is beyond the realm of this particular discussion.