The vehicle lamp specifications are given below, high beam - Type 9006, low beam - Type 9005, front parking light/turn signal - 12V 21/5W,
Fog Lights - Type 9006, brake light - 12V 21W, turn signal - 12V 21W, tail light - 12V10W, rear fog light-12V21W, backup light-12V21W, license plate light -Type C11 /2 V5 W,and instrument lights -Type W1.2/1.2/1.2/1.8(Shawn & Metzler). When removing and installing headlights make sure that you do not touch the clear lens of the bulb. If touched or exposed to dirt clean with a soft cloth soaked in alcohol and then dry before fitting it back.To pull out the bulb unplug the electrical connector while rotating it counter clockwise .After about one fifth of a complete rotation anticlockwise ,the locking tabs should line up with slots in the headlight housing.The new lamp can be put into position by rotating it clockwise so that it locks in place.For aiming headlamps,the vehicle should be parked on level ground facing a flat wall approximately twenty-five feet away.If any equipped, remove stone shields and switch on your lights.The horizontal distance between the beams on the wall should be equal to that between them in reality; besides this regard has been taken for vertical height of beams above ground.Finally check operations of both lights which have to come on properly as well as consistency of their illumination pattern (Morris).