BMW 07119906503 Fog Lamp Bulb

When you replace bulbs, take some precautions including ensuring that the bulb is not hot in case it was used recently, separating the battery before working on bulb contacts to clean any corrosion or dirt for correct metal-to-metal contact and handling a new bulb with care without touching the glass so as to avoid moisture and grease contamination. For exterior lights such as xenon (HID) headlights or halogen headlights, access them through covers or caps, disconnect electrical connectors and release retaining clips replacing bulbs making sure to avoid touching the bulb glass. The low-beam bulbs are accessible through an inner fender liner flap while front side marker/turn signal/side turn light/front fog light/high-mount brake light bulbs have specific procedures for removal and installation. Body-mounted rear lights on sedan E-series chassis models and F-series chassis models are accessed by releasing retaining clips or removing taillight housing; sports wagon models are accessed differently from this. Trunk lid-mounted/tailgate-mounted/license plate lightbulbs each have their own individual steps for replacement. Interior lights like center light unit bulbs/front light unit bulbs/footwell light bulbs/trunk light bulbs/instrument panel lights/glove box lightbulbs/heater/air conditioning control panel switch illumination/vanity lights LED specific procedure available for their removal and installation where non-replaceable is stated in some cases.

Remove the wheel housing trim and work behind the end of the front bumper cover by detaching the foglight harness connector and twisting the foglight socket to remove it. Replace the bulb without touching its surface with bare fingers, as grease from the skin can cause premature failure. The installation process is the reverse of removal, and adjust the foglight aim through the slot in the front bumper cover.

Remove the air filter housing.

To replace the halogen high beam bulb, grip the bulb socket and pull it out of the headlight, detach the bulb from the socket, and remove it.

Body-mounted rear lights on sedan E-series chassis models and F-series chassis models can be accessed by either releasing retaining clips or removing the taillight housing.