BMW 61663403211 Windshield Washer Fluid Reservoir

At the right front of the engine compartment, it is advisable to siphon out washer fluid from the reservoir. When you wish to remove the reservoir, then you slide off the mounting nut and then disconnect the hoses and the electrical connectors from the fluid pumps and the fluid level switch. Detach the hose and pull the reservoir straight up off the mounting slot with a view to holding a container to catch any dripping fluid. here is the level switch mounted: This must be found under the reserator. To install, reverse the above steps of removal by fixing the lug at the base on to the mount and while doing that ensure that the hoses are not twisted. Last, fill up the reservoir and ensure that there is any leakage as this completes the function of the system.

Open the engine hood and work at the right front of the engine compartment to siphon out washer fluid from the reservoir. For the washer fluid level switch replacement, locate it under the washer reservoir near the headlamp, partially remove the washer reservoir to ease removal, detach the electrical connector, and carefully pry the sensor out of the reservoir while being prepared to catch any dripping fluid. For the headlight washer pump replacement, detach the electrical connector, remove the hose from the pump, and carefully pry the pump out of the reservoir, again being prepared for dripping fluid. For the rear window washer pump or windshield washer pump replacement, detach the electrical connector, remove the hose from the pump, and carefully pry the pump out of the reservoir, ensuring to catch any dripping fluid. Installation is the reverse of removal, noting to coat the grommet at the base of the pump or sensor with an anti-friction agent, check that fluid hoses are not kinked after installation, fill the reservoir, and check for leaks.