How to remove and reinstall the MAP Sensor in N54 six cylinder engine on BMW 335i?

Switch ignition OFF and remove the key. Remove the cabin microfilter housing. Working at the rear of the intake manifold, detach the sensor electrical connector, remove fasteners, and then remove the sensor. Installation is the reverse of removal, ensuring to inspect the O-ring and replace it if necessary. After reinstalling, check for fault codes and reset ECM memory.

Genuine BMW 335i MAP Sensor

Manifold Air Pressure Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Series

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

5 MAP Sensors found

View related parts
BMW 335i Manifold Absolute Pressure Sensor
Part Number: 13628644432
$113.22 MSRP: $162.95
You Save: $49.73 (31%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Pressure sensor; Boost Sensor, M.A.P. Sensor, MAP Sensor
- Replaces: 13-62-7-599-042
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 2011-2015 BMW 335i | Convertible(E93), Coupe(E92), Sedan(E90), Sedan(F30)
View related parts
BMW 335i Manifold Absolute Pressure Map Sensor
Part Number: 13627599042
$113.22 MSRP: $162.95
You Save: $49.73 (31%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Pressure Sensor
- Replaced by: 13628644432
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 2011-2015 BMW 335i | Convertible(E93), Coupe(E92), Sedan(E90), Sedan(F30)
View related parts
BMW 335i Pressure Sensor
Part Number: 13627585493
$113.22 MSRP: $162.95
You Save: $49.73 (31%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Replaced by: 13629797773
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 2007-2013 BMW 335i | Convertible(E93), Coupe(E92), Sedan(E90)
View related parts
BMW 335i Pressure Sensor
Part Number: 13629797773
$113.22 MSRP: $162.95
You Save: $49.73 (31%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: M.A.P. Sensor, MAP Sensor
- Replaces: 13-62-7-551-429, 13-62-7-585-493
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 2007-2013 BMW 335i | Convertible(E93), Coupe(E92), Sedan(E90)
View related parts
BMW 335i Manifold Absolute Pressure Sensor
Part Number: 13627585492
$113.22 MSRP: $162.95
You Save: $49.73 (31%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Pressure Sensor; M.A.P. Sensor, MAP Sensor
- Replaces: 13-62-7-560-063
- Warranty: This genuine part is guaranteed by BMW's factory warranty.
Fits the following Vehicles:
- 2007-2010 BMW 335i | Convertible(E93), Coupe(E92), Sedan(E90)

BMW 335i MAP Sensor

The BMW 335i MAP Sensor constantly monitors absolute pressure inside the intake manifold so the engine computer can balance fuel and spark for smooth power. Mounted on the plastic manifold, this MAP Sensor senses how much air is being pushed by the turbo, translates that reading into an electrical signal, and allows the BMW ECU to inject exactly the right fuel mass while also refining ignition timing and EGR checks. Because the 335i employs forced induction it pairs the MAP Sensor with a MAF unit, yet in speed density mode the ECU can rely on pressure and intake temperature alone to judge air density and keep the twin scroll turbo happy at every rpm, and each MAP Sensor passes OBD II tests that watch EGR performance. Across production years BMW kept the same basic solid state design, but calibration differed, early 335i units were rated for slightly lower boost while later 335i software expanded the pressure window to handle performance updates, the core measuring principle never changed. A healthy BMW MAP Sensor means quicker throttle response, better mileage, clean diagnostic feedback, and dependable power for daily driving.

If you are looking for OEM BMW 335i MAP Sensor, we highly recommend to shop with us. Not only do we offer budget friendly prices, but we also provide fast delivery. In addition, we have a hassle-free return policy on all genuine BMW 335i MAP Sensor that come backed by the manufacturer's warranty.

BMW 335i MAP Sensor Parts Questions & Experts Answers

Pressure Sensor
13627585493
Q:
How to remove and reinstall the MAP Sensor in N54 six cylinder engine on BMW 335i?
Posted by Jonas M.
A:
Switch ignition OFF and remove the key. Remove the cabin microfilter housing. Working at the rear of the Intake Manifold, detach the sensor electrical connector, remove fasteners, and then remove the sensor. Installation is the reverse of removal, ensuring to inspect the O-ring and replace it if necessary. After reinstalling, check for fault codes and reset ECM memory.
Answered by BMW Parts Specialist Brad / Dec 28, 2025